Production Steps of ZKG Series Vacuum Rake Drying Equipment

213 views

Production Steps of ZKG Series Vacuum Rake Drying Equipment

The production steps of ZKG series vacuum rake drying equipment follow a complete batch operation cycle:

  1. Pre-start inspection of seals and piping: Confirm the vessel cover is locked, the sealing ring is intact, and the jacket and condenser piping are clear.
  2. Manual barring to confirm no jamming: Rotate the rake shaft by one turn and check for abnormal noise or sticking, with lubrication in normal condition.
  3. Close discharge valve before loading: Confirm the bottom discharge valve is tightly closed to prevent premature material leakage.
  4. Metered loading and sealing of feed port: Load material to 30%–70% of volume, then close the feed port to ensure the vessel is sealed.
  5. Start vacuum pump for pre-evacuation: First evacuate the vessel to the set negative pressure, usually controlled at ≤ -0.08 MPa.
  6. Low-speed forward and reverse rake agitation: After the vacuum target is reached, start agitation at a low speed of 5–15 rpm.
  7. Slowly introduce jacket heating medium: Gradually introduce steam, hot water, or thermal oil to avoid sudden heating that may cause bumping and splashing.
  8. Staged temperature rise to remove free water: Remove surface moisture at low temperature initially, then moderately raise temperature to remove bound moisture.
  9. Crushing rods break up caked material: Crushing rods between rake teeth move up and down with the shaft, knocking material off the wall and breaking up agglomerates.
  10. Condense and recover solvent with monitoring: Vapor is liquefied and recovered through the condenser; observe condensate dripping to judge process progress.
  11. Comprehensive determination of drying endpoint: Judge the endpoint based on stable vacuum, cessation of condensate dripping, and material temperature approaching jacket temperature.
  12. Stop heating, cool, and reverse-rake discharge: Stop heating first, cool the material below 60°C, break vacuum, and reverse the rake teeth to assist discharge.

 

 

 

 

 

 

 

YANCHENG QUANPIN MACHINERY CO.. LTD
Sales Manager - Stacie Tang
MP: +86 19850785582
Tel: +86 0515-69038899
E-mail: stacie@quanpinmachine.com
WhatsAPP: 8615921493205

https://www.quanpinmachine.com/

https://quanpindrying.en.alibaba.com/

Address: Jiangsu Province, China.


Post time: Nov-16-2026