Working Principle of SZG Series Double-Cone Rotary Vacuum Drying Equipment
The working principle of SZG series double-cone rotary drying equipment centers on the coupling of three elements: jacket conduction heating, vacuum lowering the boiling point, and rotation/tumbling enhancing heat and mass transfer. It can be broken down into the following 12 stages:
- Closed loading into double-cone vessel: Material is vacuum-loaded into the closed double-cone vessel, with loading strictly controlled below half of the total volume.
- Hot medium fed into jacket: Hot water, low-pressure steam, or thermal oil is fed into the jacket, transferring heat indirectly to the material through the inner wall.
- Low-speed rotation and tumbling: The vessel rotates slowly around a horizontal axis, and the material tumbles continuously along a rhombic trajectory up and down and inward and outward.
- Wall contact renews heat transfer: Tumbling makes the material repeatedly contact and leave the hot wall, continuously renewing the heated surface to enhance conduction.
- Vacuum system establishes negative pressure: The vacuum pump evacuates the vessel to negative pressure, lowering the boiling point of moisture or solvent on the material surface.
- Low-temperature surface evaporation: Under vacuum, moisture vaporizes at a lower temperature, protecting heat-sensitive components from high-temperature damage.
- Internal moisture diffuses to surface: A humidity gradient forms between the material interior and surface, and moisture continuously migrates to the surface to replenish it.
- Vapor discharged through vacuum pipe: The evaporated vapor is promptly withdrawn from the vessel by the vacuum pump through the exhaust pipe, maintaining the drying driving force.
- Bag filter intercepts fine powder: A special bag filter in the suction path intercepts fine powder entrained by the airflow, preventing material loss and contamination.
- Condenser recovers solvent: Solvent-laden vapor is condensed and recovered by a one- or two-stage condenser, with a recovery rate of over 90%.
- Nitrogen protection against oxidation: For oxidizable materials, nitrogen can be introduced to displace air, reducing the oxygen content inside the vessel and preserving quality.
- Endpoint judgment, cooling, and discharge: The endpoint is judged by temperature, vacuum degree, or solvent recovery amount; after cooling, the vessel is rotated to discharge.